Mortar spraying machine common fault of how to solve problems, such as checking the compressor does not turn on the supply line of the components are normal, the gas needle, trachea no plug, pressure gauge switch has been raised to the correct reading, various switches, valves are in normal state . The only pressure switch can only take pulled out two lines, and two lines, and together, squeeze mortar sprayer, air compressor can start up, compressor without damage. The reason is still the supply line. Available turned the gas generated by the compressor to blow the pipes clean. If you still have problems, pressure gauge switch to replace (after first use of the stick tapping pressure switch, piston mortar spraying machines, test is bad, this situation is also possible). Mortar spraying machine usage and maintenance points heating thermostat: ① temperature "set - temperature" selection switch to the "Settings" at adjusting the thermostat knob to the desired setting digital display temperature. ② The temperature "set - temperature" selection switch to the "temperature" of the dry mortar spraying machine, digital display of the actual temperature of the solution. (Red indicator light, said heater) work is completed, Haikou mortar spraying machine, speed control knob minimum position, the thermostat knob in the non-working state, closed stirring switch and power switch off the power. Wipe the column, Face, fixtures, sensors, which does not allow residual water droplets and dirt. Haikou mortar spraying machine, HTC environmental protection, dry mortar spraying machine provided by the Xinxiang City Hongda energy saving equipment Limited. Haikou mortar spraying machine, HTC environmental protection, dry mortar spraying machine Xinxiang City Hongda energy saving equipment Limited (www.xxhdjnhb.com) this year introduced a new upgrade, the above picture is for reference only, please call this page or image Contact phone, for the latest information, contact: Yu Jingli.