Mortar spraying machine if there is no time off due to a fault occurs, leading to plugging quite serious, the first relief still need to reverse the new mortar spraying machine, and then remove the gun down, remove the stuck pipe, there is water in places with appropriate diameter hoses inserted into the pipeline flushing. Flushing must be repeated until the output port is not only the sand slurry pipe appear spraying equipment can be replaced. The piping must be rinsed Run-operated small mortar spraying machine again, it will easily happen again plugging mortar spraying machine model, because the pipeline would wash off the remaining part of the water and sand, mortar, water will be isolated, thus reducing the fluidity mortar produce plugging. Mortar spraying machine spraying a small amount of the issue screw rotor, stator wear mortar spraying machine, after the flow was significantly reduced wear mortar, mortar spraying pressure and the compressed air pressure can not match, resulting in uneven coating, partial material and so on. General solution is to replace the rotor, stator, if the front jacket of the adjustment device, you can continue to use the appropriate tone for some time tightly hoop bolts. Standard mortar spraying machine, Shandong mortar spraying machine, environmental protection provided by the Xinxiang City Hongda Hongda energy saving equipment Limited. Xinxiang City Hongda energy saving equipment Limited (www.xxhdjnhb.com) strong, credible, in Xinxiang mortar industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead HTC into the brilliant green and you work for a better future!