Mortar spraying machine gun spraying a small amount of gas needle position problem cause the material is uneven, each time before spraying from the air must first adjust the needle opening between the mouth and the gun, was adjusted to the optimum position locking bolts gas needle and record the location of the gas needle. During spraying operations due to the constant movement of the external wall insulation mortar spraying machine gun, it can easily lead to gas needle position, causing the material is uneven, as long as the gas needle position adjustment to the initial position can be recorded in this case. Hopper loading operation to be uniform, without interruption dry mortar sprayer, when the conveying screw rotates, is prohibited in the hopper stirring with sticks, to prevent injury. Once the spraying duct blockage, will switch to switch to manual position, and only the compressor, the quick connector Remove the front head, but will spray upside down solid block, a reverse pressure air pressure, the delivery tube is blown over the slurry, In the quick connector mounted on the interior walls mortar spraying machine, began to work. Jet-hand operation, should wear safety helmets, safety glasses, protective clothing and other protective equipment. Screw supercharger to boost pouches and wearing parts for long life, during the initial use, boost the stator bolt in a loose state more until the pressure is reduced, the adjustment bolts when flow was significantly reduced, so that in normal working conditions. Rapid mortar spraying machine | Zhumadian mortar spraying machine | Honda Honda Xinxiang City Environmental Protection is provided by energy saving equipment Limited. Xinxiang City Hongda energy saving equipment Limited (www.xxhdjnhb.com) strong, credible, in Xinxiang mortar industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead HTC into the brilliant green and you work for a better future!